All Star Wash Inc.

SS

Stiven Solomonov

Founder, All Star Wash Inc.

Stiven Solomonov is the founder of All Star Wash Inc., a mobile commercial cleaning company serving Ontario since 2012. Under his leadership, All Star Wash has grown into a full-service provider covering mobile fleet washing, truck washing, fleet cleaning, fleet detailing, interior steam detailing, dedicated fleet programs, and heavy equipment washing and detailing for commercial fleets, contractors, and large-scale operations across Toronto and the GTA.

24 Articles Published
RV Care

Can You Pressure Wash an RV? What Is Safe and What Isn't

Sometimes, but not with the kind of pressure washer you would use on a deck. RV experts who allow it keep the pressure low, roughly 1,300 psi at most in the sources below, hold the nozzle well back from the surface, and keep spray away from seals, decals, windows, vents and the roof. Others say a garden hose and a soft brush are enough. The risk is not dirt coming off. It is water forced into places that were only built to shed rain.

If you would rather not take that risk with your own RV, an RV washing service does the rinsing for you. If you are doing it yourself, this guide covers what the experts say about pressure, where damage happens and how to rinse safely.


01

What the Experts Say About Pressure

The sources split, so here is where each one lands.

SourcePositionPressure figure
RV.com's guide to washing an RVAdvises against a pressure washer unless you are a professionalStay within garden-hose pressure with a sprayer
RVBlogger"The simple answer is, no"If you still do it, no more than 1,200 to 1,300 psi
Do It Yourself RVUse only a model made for RVs, or wash by handAbout 1,100 to 1,300 psi. "If you're in doubt, don't use a pressure washer at all"
Dave Solberg, an RV technician writing on RVtravelDeck-grade washers are generally unsuitableMore than 2,000 psi or 2 gallons a minute can peel back sealants and decals and harm the finish. He suggests about 1,200 psi
Solberg's earlier answerNot a fan unless you know the pressure and the tipUnder 1,000 psi, or a garden hose
Camping World's guide to washing an RVDoes not ban itLearn to use it first, keep a safe distance, and remember a soft brush and a hose are usually enough

No source recommends a deck-cleaning washer. The highest figure any of them accepts is about 1,300 psi, and several would rather you used a hose.


02

Where Pressure Does the Damage

A pressure washer does not usually hurt the sidewall itself. It forces water past the things that keep water out.

AreaThe riskThe safer approach
Sealant and caulkingPressure can strip it or blow past it. Solberg says that if butyl, lap or corner sealant has dried or separated, a pressure blast can push moisture inRinse gently, and check sealants before any wash
Decals and graphicsLifted edges, peeling and blistering. RVBlogger notes lifted decals also hurt resale valueLow pressure, or a soft brush and microfiber cloth
WindowsWater can enter through weep holes and slider-window frames. Solberg warns a direct hit there "will get water inside the rig"Wash windows by hand. Do It Yourself RV says a distant rinse is acceptable
Sidewall damageHairline cracks, pin holes and scratches let pressure force water in. Ribbed sidewalls have seams that can admit moistureLook the sidewalls over first and keep away from damaged spots
Vents and clearance lightsSolberg lists refrigerator vents, plumbing vents and marker lights as spots that need careKeep spray off them
Rooftop vents and air conditionerDo It Yourself RV says to block off rooftop vents and openings so no water or soap leaks into the air conditionerBlock openings before rinsing, or use a hose
FiberglassDo It Yourself RV says it is more brittle than metal siding and more prone to damage, especially when oldLowest pressure, widest spray
AwningsThor Motor Coach's exterior care guide warns that too much pressure can damage the fabric or its coatingKeep it light
TiresThe sources disagree. RVBlogger says tires should never be pressure washed, while Do It Yourself RV says to use low pressureUse a soft brush and mild detergent, as covered in the wash guide

03

Pressure, Tip and Distance

The psi number on the box is only part of it.

The tip matters. Solberg says to stay away from a red tip, because it creates a pin-hole blast that can cut decals and sealant. Pressure is also rated at the pump, so the spray at the gun can differ from the label.

Lower the pressure. Solberg suggests lowering the unloader setting or fitting a larger-orifice tip to reduce the pressure at the nozzle.

Hold it back. Do It Yourself RV says to keep the nozzle at least a foot from the surface and to avoid caulking, decals, vents and rubber parts.

Do not aim straight at the surface. The same guide says to angle the spray, because pointing it directly at the surface can cause major problems.

Stop at the first sign of trouble. If you see weakened, stripped or dented areas, stop immediately.


04

What About the Roof?

Be more careful here. Camper Smarts' roof guide says to avoid pressure washing a roof unless the RV or roof manufacturer specifically allows it. Solberg says many rubber roof makers advise against it and recommend a garden hose with mild detergent, because direct pressure could cut or peel the membrane where there is already a tear or pin hole. RVBlogger also says to avoid pressure washers on roofs. The roof methods are in how to clean an RV roof.


05

A Safer Way to Rinse and Wash

The sources that discourage pressure washers all land in the same place.

Check with the maker first. RVBlogger says to check with your manufacturer or dealer before using a pressure washer at all.

Rinse with a garden hose. Wet the roof and sidewalls and let the water do the first pass.

Apply soap with a foam or soap cannon. Solberg suggests mild detergent through a low-pressure soap cannon.

Scrub gently. Use a soft brush or microfiber cloth. RVBlogger recommends a long-handled soft-bristled brush for high areas.

Work top-down and keep the sides wet. Solberg keeps the walls wet while working on the roof so residue does not dry on them.

Rinse well and check the inside afterward. Look at the storage bins, windows and the inside of the entry door for moisture.

The full routine is in how to wash an RV yourself, step by step.


06

Mistakes That Damage an RV

Using a deck washer. More than 2,000 psi is where Solberg says sealants and decals start to peel.

Using a red or pin-point tip. It can cut decals and sealant.

Spraying windows and vents directly. Water goes where it was never meant to.

Skipping the sealant check. A washer finds the weak seam for you.

Not checking inside afterward. A small leak does the most harm when nobody sees it.


07

Frequently Asked Questions

Q:

What psi is safe for an RV?

A:

The sources range from garden-hose pressure to about 1,300 psi at the most, and none recommends more. If you are not sure, use less and keep further back.

Q:

Can I pressure wash fiberglass?

A:

Do It Yourself RV says fiberglass is more brittle than metal siding and more prone to damage, especially when old, so use the lowest pressure.

Q:

Can I pressure wash the awning?

A:

Thor warns that too much pressure can damage the fabric or its coating. Keep it light.

Q:

Can pressure washing cause a leak?

A:

Yes. Solberg says a direct hit at window frames and sealant can put water inside the rig, and he calls a reader lucky that no water got in.

Q:

Is a garden hose enough?

A:

Camping World says a soft brush and a hose are usually enough. Several of the sources above start from that.


08

When Hiring It Out Makes Sense

A tall coach with sealants you cannot check, a roof you should not walk on and decals that are already lifting are the usual reasons owners hand the job off. We use a hot-water unit with steam, soft-bristle brushes and RV soap, and we work carefully around seals, decals, vents and trim. If you want that done for you, you can request a free quote.

Free Quote

Request an RV Wash Quote

    Leave a Comment

    Your email address will not be published. Required fields are marked *